Home › Power Source / Network › 1KD-FTV BATTERY / CHARGING › GENERATOR(for DENSO Made) › from 2012.10
RM1840EF _57 Power Source / Network _009635 1KD-FTV BATTERY / CHARGING _0052669 GENERATOR(for DENSO Made) A

1KD-FTV BATTERY / CHARGING  GENERATOR(for DENSO Made)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.REMOVE NO. 2 IDLER PULLEY ASSEMBLY

A233180

a.

Remove the bolt, pulley plate, No. 2 idle pulley and spacer.


Hide 6.REMOVE GENERATOR ASSEMBLY

A195391

a.

Remove the nut and generator wire.


b.

Disconnect the generator connector.


c.

Remove the 2 bolts and generator.