Home › Power Source / Network › 2TR-FE BATTERY / CHARGING › GENERATOR › 2011.10–2012.01
RM1840EF _57 Power Source / Network _009636 2TR-FE BATTERY / CHARGING _0052672 GENERATOR A

2TR-FE BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See pageGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE INTAKE AIR CONNECTOR AND AIR CLEANER ASSEMBLY

Hide 5.REMOVE GENERATOR ASSEMBLY

A099681

a.

Detach the terminal cap.


b.

Disconnect the generator connector.


c.

Remove the nut and bolt and disconnect the generator wire.


d.

Remove the 2 bolts and generator.