Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(for Non-built-in Type Door Control Receiver) › 2011.10–2012.10
RM1840EF _58 Vehicle Interior _009640 DOOR LOCK _0052679 WIRELESS DOOR LOCK CONTROL SYSTEM(for Non-built-in Type Door Control Receiver) J

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(for Non-built-in Type Door Control Receiver)  No Answer-Back  


DESCRIPTION

In this case, wireless control functions are normal but the hazard warning light and side turn signal light answer-back is not normal (the driver side junction block's turn signal flasher output may be malfunctioning).

WIRING DIAGRAM

B276306
5.573,0.792 5.885,0.969 0.313,0.177 10 false HAZ 0.979,0.802 1.292,0.979 0.313,0.177 10 false HAZ 0.365,1.208 0.677,1.385 0.313,0.177 10 false G54 0.365,1.365 1.594,1.906 1.229,0.542 10 false Turn Signal Flasher Assembly 4.896,0.802 5.115,0.948 0.219,0.146 10 false 2O 4.906,0.604 5.115,0.75 0.208,0.146 10 false 25 4.896,1.448 5.115,1.594 0.219,0.146 10 false 2N 2.385,1.448 3.979,2.042 1.594,0.594 10 false to Hazard Warning Signal Switch Assembly 4.865,1.698 6.656,2.229 1.792,0.531 10 false Driver Side Junction Block Assembly (Integration Relay) 4.906,1.26 5.115,1.406 0.208,0.146 10 false 25 5.323,0.719 5.51,0.865 0.188,0.146 10 false 18 1.375,0.719 1.5,0.865 0.125,0.146 10 false 8

PROCEDURE

1.CHECK HAZARD WARNING LIGHT OPERATION
a.

Check that the hazard warning lights and side turn signal lights flash when the hazard warning signal switch assembly is pressed.

OK:

Hazard warning lights and side turn signal lights flash when hazard warning signal switch assembly is pressed.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK - TURN SIGNAL FLASHER)

NG

2.CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK - TURN SIGNAL FLASHER)
a.

Disconnect the 2O driver side junction block assembly connector.


b.

Disconnect the G54 turn signal flasher assembly connector.


c.

Measure the resistance of the wire harness side connectors.

Standard Resistance:
Tester Connection Condition Specified Condition
2O-25 (HAZ) - G54-8 (HAZ) Always Below 1 Ω
2O-25 (HAZ) or G54-8 (HAZ) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR