CHECK THEFT WARNING ECU ASSEMBLY
Disconnect the G29 theft warning ECU assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G29-1 (E) - Body ground | B-W - Body ground | Ground | Always | Below 1 Ω |
| G29-4 (+B1) - G29-1 (E) | L-Y - B-W | Battery power supply (power supply for ECU) | Always | 11 to 14 V |
| G29-14 (+B2) - G29-1 (E) | G - B-W | Battery power supply (for actuator operation) | Always | 11 to 14 V |
| G29-18 (IG) - G29-1 (E) | R-L - B-W | Ignition power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the G29 theft warning ECU assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G29-5 (KSW) - Body ground | G-Y - Body ground | Unlock warning switch input signal | No key in ignition key cylinder | 10 kΩ or higher |
| Key inserted in ignition key cylinder | Below 1 Ω | |||
| G29-7 (CTY) - G29-1 (E) | R-L - B-W | All courtesy light switches input signal | One or more doors open | Below 1 V |
| All doors closed | 11 to 14 V | |||
| G29-9 (DSWH) - G29-1 (E) | G-R - B-W | Hood lock assembly (security courtesy switch) input signal | Engine hood fully closed | Below 1 Ω |
| Engine hood open | 10 kΩ or higher | |||
| G29-11 (HORN) - G29-1 (E) | W-R - B-W | Vehicle horns output signal | Alarm sounding state | Below 1 V |
| Armed state | 11 to 14 V | |||
| G29-13 (SH-) - G29-1 (E) | B - B-W | Security horn output signal | Security horn assembly is sounding
(theft deterrent system is in alarm sounding state) |
Alternating between below 1 V and 11 to 14 V |
| G29-27 (IND) - G29-1 (E) | G-R - B-W | Security indicator light assembly output signal | Security indicator light is flashing
(theft deterrent system is operating) |
Alternating between
below 1 V and 11 to 14 V |
| G29-28 (HAZD) - G29-1 (E) | G-O - B-W | All hazard warning light output signals | Hazard warning lights and side turn signal lights are flashing
(theft deterrent system is in alarm sounding state) |
Below 1 V |
If the result is not as specified, the theft warning ECU assembly may have a malfunction.