Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2011.10–2012.04
RM1840EF _58 Vehicle Interior _009641 THEFT DETERRENT / KEYLESS ENTRY _0052688 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Rear Door Courtesy Switch RH Circuit  


DESCRIPTION

The theft warning ECU assembly detects the condition of the rear door courtesy light switch assembly RH.

WIRING DIAGRAM

B276107
5.625,0.781 5.938,0.958 0.313,0.177 10 false CTY 4.979,1.521 5.292,1.698 0.313,0.177 10 false G29 4.979,1.698 6.865,1.875 1.885,0.177 10 false Theft Warning ECU Assembly 1.979,1.656 2.292,1.833 0.313,0.177 10 false K11 1.979,1.844 3.573,2.24 1.594,0.396 10 false Rear Door Courtesy Light Switch Assembly RH 5.427,0.688 5.552,0.865 0.125,0.177 10 false 7 1.76,1.417 1.885,1.594 0.125,0.177 10 false 1

PROCEDURE

1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH
a.
B276106
0.438,1.74 0.625,1.74 0.625,1.74 0.854,1.375 true 0.958,0.24 1.271,0.396 0.313,0.156 10 false *a 0.99,0.677 1.302,0.833 0.313,0.156 10 false *b 0.25,1.656 0.563,1.813 0.313,0.156 10 false *c
*a Not pushed (ON)
*b Pushed (OFF)
*c Body ground


Remove the rear door courtesy light switch assembly RH.

Click hereVehicle Interior>LIGHTING (INT)>REAR DOOR COURTESY SWITCH>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - Body ground Not pushed (ON) Below 1 Ω
Pushed (OFF) 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH RH - THEFT WARNING ECU)

NG

REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH

2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH RH - THEFT WARNING ECU)
a.

Disconnect the K11 rear door courtesy light switch assembly RH connector.


b.

Disconnect the G29 theft warning ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K11-1 - G29-7 (CTY) Always Below 1 Ω
K11-1 or G29-7 (CTY) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR