If the engine does not start and no DTCs are output, the following conditions may apply.
There is an open or short circuit between the telephone transceiver assembly and the ECM or transponder key ECU assembly.
The blocking system is set.
Before troubleshooting this symptom, make sure no engine immobiliser system DTCs or blocking system DTCs are present. If present, troubleshoot the engine immobiliser system DTCs or blocking system DTCs first.
When replacing the telephone transceiver assembly, refer to the Service Bulletin.
When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the blocking system setting.
Check with the customer's contracted service provider to determine whether the blocking system is set.
| Result | Proceed to |
|---|---|
| Blocking system is set. | A |
| Blocking system is unset. | B |
A
B
| *1 | Waveform |
| *a | Component with harness connected
(Transponder Key ECU Assembly) |
Using an oscilloscope, check the waveform.
| Item | Content |
|---|---|
| Tester Connection | G26-13 (EFIO) - G26-16 (GND) |
| Tool Setting | 10 V/DIV., 100 ms./DIV. |
| Condition | Ignition switch ON |
The waveform shown in the illustration is an example for reference only. Noise, chattering, etc. are not shown.
Check the waveform when the security indicator light is off (the engine immobiliser system is unset). If the security indicator light does not turn off (the engine immobiliser system cannot be unset), refer to the engine immobiliser system.
Waveform is output normally (refer to illustration).
| Result | Proceed to |
|---|---|
| NG (stuck LOW) | A |
| NG (stuck HI) | B |
| OK | C |
A
B
C
Temporarily replace the transponder key ECU assembly with a new one (Refer to the Service Bulletin).
| Proceed to |
|---|
| NEXT |
NEXT
Register the ECU - ECM communication ID (Refer to the Service Bulletin).
| Proceed to |
|---|
| NEXT |
NEXT
Check that the engine starts normally.
Engine starts normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Register the ECU - ECM communication ID (Refer to the Service Bulletin).
| Proceed to |
|---|
| NEXT |
NEXT
Check that the engine starts normally.
Engine starts normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG