CHECK THEFT WARNING ECU ASSEMBLY (w/ Theft Deterrent System)
Disconnect the G29 theft warning ECU connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G29-4 (+B1) - Body ground | L-Y - Body ground | Battery power supply | Always | 11 to 14 V |
| G29-14 (+B2) - Body ground | G - Body ground | Battery power supply | Always | 11 to 14 V |
| G29-18 (IG) - Body ground | R-L - Body ground | Ignition power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| G29-1 (E) - Body ground | B-W - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the G29 theft warning ECU connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G29-3 (DMLP) - Body ground | P - Body ground | Interior lights signal | Interior lights on | Below 1 V |
| Interior lights off | 11 to 14 V | |||
| G29-7 (CTY) - Body ground | R-L - Body ground | All courtesy switch signals | Driver side, front passenger side, rear RH* or rear LH* door closed | 11 to 14 V |
| Driver side, front passenger side, rear RH* or rear LH* door open | Below 1 V |
*: for Double Cab
If the result is not as specified, the theft warning ECU may have a malfunction.