Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2011.10–2012.01
RM1840EF _58 Vehicle Interior _009645 SUPPLEMENTAL RESTRAINT SYSTEMS _0052710 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B277147
2.708,1.521 1.854,0.927 true 2.781,1.479 3.083,1.719 0.302,0.24 10 false *1
*1 Protective Tape


Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 3 steering wheel cover.

HINT:

Protective tape the screwdriver tip before use.



Hide 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
B277148
1.552,1.073 1.219,2.052 true 1.521,3.135 1.167,4.135 true 1.115,2.083 1.49,2.385 0.375,0.302 10 false *1 1.042,4.146 1.375,4.427 0.333,0.281 10 false *1 0.063,0.104 0.396,0.427 0.333,0.323 10 false *A 0.104,2.229 0.583,2.604 0.479,0.375 10 false *B
*A w/o Cruise Control System
*B w/ Cruise Control System
*1 Protective Tape


Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 2 steering wheel cover.

HINT:

Protective tape the screwdriver tip before use.



Hide 5.REMOVE STEERING PAD

a.
B293965
0.417,2.938 0.688,2.625 false 0.25,2.896 0.594,3.177 0.344,0.281 10 *1
*1 Screw Case


Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.


b.
B277210

Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

NOTICE:

When removing the steering pad, do not pull the airbag wire harness.



c.

Disconnect the horn connector.


d.

Disconnect the connector and remove the steering pad.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.