Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Separate Seat Type)
RM1840EF _58 Vehicle Interior _009646 SEAT _0052717 FRONT SEAT ASSEMBLY(for Separate Seat Type) A

SEAT  FRONT SEAT ASSEMBLY(for Separate Seat Type)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

a.

Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Connect the connector and attach the wire harness clamp under the seat.


c.

for Front Passenger Side, w/ Seat Belt Warning system:

Connect the connector and attach the wire harness clamp under the seat.


d.

Temporarily install the front seat assembly with the 4 bolts.


e.

Lift up the seat track handle sub-assembly LH and move the seat to the rearmost position.


f.
B207785
3.124,2.183 3.321,2.356 0.197,0.172 10 (1) 2.413,2.922 2.611,3.095 0.197,0.172 10 (2)

Tighten the bolts in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


g.

Lift up the seat track handle sub-assembly LH and move the seat to the foremost position.


h.
B207784
0.275,1.996 0.468,2.166 0.193,0.17 10 (1) 0.422,1.413 0.615,1.584 0.193,0.17 10 (2)

Tighten the bolts in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


Hide 2.INSTALL FRONT SEAT HEADREST ASSEMBLY

a.

Install the front seat headrest assembly.


Hide 3.INSTALL SEAT TRACK COVER LH (w/ Cover)

a.
B342865
1.875,1.594 2.333,1.792 0.458,0.198 10 false (1) 0.458,1.521 0.917,1.719 0.458,0.198 10 false (2)

Attach the 2 claws in the order shown in the illustration to install the seat track cover LH.

NOTICE:

Be careful not to damage the claws.



Hide 4.INSTALL INNER SEAT TRACK BRACKET COVER LH (w/ Cover)

a.
B342866
1.479,1.719 1.938,1.917 0.458,0.198 10 false (1) 2.771,1.531 3.229,1.729 0.458,0.198 10 false (2)

Attach the 2 claws in the order shown in the illustration to install the inner seat track bracket cover LH.

NOTICE:

Be careful not to damage the claws.