Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)
RM1840EF _58 Vehicle Interior _009647 SEAT BELT _0052732 FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat) G

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT SEAT INNER BELT ASSEMBLY RH

a.

Measure the resistance according to the value(s) in the table below.

B282484
2.073,1.042 1.604,1.229 true 2.438,1.042 2.969,1.25 true 1.604,0.833 1.833,1.021 0.229,0.188 10 false *1 2.156,0.104 2.375,0.292 0.219,0.188 10 false *a 3.969,0.865 4.229,1.063 0.26,0.198 10 false *2 4.604,0.104 4.865,0.313 0.26,0.208 10 false *a 3.021,1.219 3.188,1.438 0.167,0.219 10 false + 1.448,1.167 1.667,1.344 0.219,0.177 10 false E
*1 Connector A *2 Connector B
*a Component without harness connected
(Front Seat Inner Belt Assembly RH)
- -


HINT:

Before performing the buckle switch check, inspect the separate type front seat cushion pad (See page Vehicle Interior>SEAT BELT>OCCUPANT DETECTION SENSOR>INSPECTION) to make sure the occupant detection sensor is functioning normally.


Standard Resistance:
Tester Connection Condition Specified Condition
A1 (+) - B1 Always Below 1 Ω
A2 (E) - B2 Seat belt is unfastened Below 1 Ω
A2 (E) - B2 Seat belt is fastened 1 MΩ or higher


If the result is not as specified, replace the front seat inner belt assembly RH.


Hide 2.INSPECT FRONT SEAT INNER BELT ASSEMBLY LH

a.
B276068
0.135,0.135 0.385,0.354 0.25,0.219 10 false *a
*a Component without harness connected
(Front Seat Inner Belt Assembly LH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1-2 Seat belt is unfastened Below 1 Ω
1-2 Seat belt is fastened 1 MΩ or higher


If the result is not as specified, replace the inner belt assembly LH.