Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY(for Double Cab) › 2012.04–2012.10
RM1840EF _58 Vehicle Interior _009647 SEAT BELT _0052734 FRONT SEAT OUTER BELT ASSEMBLY(for Double Cab) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for Double Cab)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT SEAT ASSEMBLY LH

Hide 6.REMOVE FRONT DOOR OPENING TRIM LH

a.

Partially remove the front door opening trim LH so that the lower center pillar garnish LH and center pillar garnish LH can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>REMOVAL).


Hide 7.REMOVE REAR DOOR OPENING TRIM LH

HINT:

Use the same procedure described for the LH side.


Hide 8.REMOVE LOWER CENTER PILLAR GARNISH LH

B284026

a.

Remove the bolt and disconnect the front seat outer belt floor anchor.


b.
B284027

Using a screwdriver, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.



c.

Detach the 2 clips and remove the lower center pillar garnish LH.


Hide 9.REMOVE SEAT BELT ANCHOR COVER CAP

a.
B282299
1.854,1.146 2.052,1.052 2.052,1.052 2.24,1.052 true 2.302,0.969 2.521,1.167 0.219,0.198 10 false *1
*1 Protective Tape


Using a screwdriver, detach the 4 claws and remove the seat belt anchor cover cap.

HINT:

Tape the screwdriver tip before use.



Hide 10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

a.
B282300

Remove the bolt and front seat outer belt shoulder anchor.


b.
B282301

w/o Pretensioner:

Remove the bolt and front seat outer belt assembly LH.


c.
B342488

w/ Pretensioner:

i.

Disconnect the pretensioner connector as shown in the illustration.


ii.
B120576

Remove the bolt and front seat outer belt assembly LH.



Hide 12.REMOVE SHOULDER BELT ANCHORAGE PLATE COVER

B284031
1.667,0.24 1.885,0.458 0.219,0.219 10 false *a
*a Slide


a.

Slide the shoulder belt anchorage plate cover upward and remove it from the center pillar garnish LH.


Hide 13.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B282303
1.337,0.985 1.509,1.188 0.172,0.203 10 *a
*a Rotate 90°


a.

Remove the bolt.


b.

Rotate the adjuster approximately 90° , and then pull and remove the front shoulder belt anchor adjuster assembly.