Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
for Separate Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Separate Seat Type)>REMOVAL)
for Bench Seat Type:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>REMOVAL)
2.REMOVE FRONT DOOR SCUFF PLATE LH
3.REMOVE FRONT DOOR OPENING TRIM LH
Partially remove the front door opening trim LH so that the lower quarter trim panel LH can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>REMOVAL).
4.REMOVE LOWER QUARTER TRIM PANEL LH
Remove the bolt and disconnect the seat outer belt floor anchor.
Using a clip remover, detach the 3 clips and remove the lower quarter trim panel LH.
5.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
| *1 | Protective Tape |
| *a | Open |
Remove the shoulder anchor.
Using a screwdriver, detach the 2 claws and open the cover.
Tape the screwdriver tip before use.
Remove the bolt and front seat outer belt shoulder anchor.
Remove the bolt and front seat outer belt assembly LH.