Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR SEAT ASSEMBLY
2.REMOVE REAR DOOR SCUFF PLATE LH
3.REMOVE REAR DOOR OPENING TRIM LH
Partially remove the rear door opening trim LH so that the lower quarter trim panel LH can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>REMOVAL).
4.REMOVE LOWER QUARTER TRIM PANEL LH
5.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt and rear seat outer belt floor anchor.
| *1 | Protective Tape |
| *a | Open |
Using a screwdriver, detach the 2 claws and open the rear seat outer belt shoulder anchor cover.
Tape the screwdriver tip before use.
Remove the bolt.
Remove the bolt and retractor of the rear seat outer belt assembly RH.