1.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
2.REMOVE COOLER SWITCH
Detach the 2 claws.
Disconnect the connector and remove the cooler switch.
3.REMOVE NO. 2 HEATER CONTROL KNOB
Remove the No. 2 heater control knob as shown in the illustration.
4.REMOVE HEATER CONTROL KNOB
Remove the heater control knob as shown in the illustration.
5.DISCONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY
Detach the 2 claws and disconnect the air inlet damper control cable sub-assembly.
6.DISCONNECT HEATER CONTROL CABLE SUB-ASSEMBLY
Detach the 2 claws and disconnect the heater control cable sub-assembly.
7.DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY
Attach the 2 claws to connect the air mix control cable sub-assembly.
8.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Disconnect the connector and remove the air conditioning control assembly.