Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 2TR-FBE)
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052750 COMPRESSOR(for 2TR-FBE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2TR-FBE)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL MAGNET CLUTCH ASSEMBLY

E171833

a.

Install the magnet clutch stator with the parts aligned as shown in the illustration.


b.
E155204

Using a snap ring expander, install a new snap ring with the chamfered side facing outward.


c.
E155205

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



d.

Install the magnet clutch washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of magnet clutch washer(s) used before disassembly.



e.
E213727
1.99,2.771 2.385,2.771 false 1.792,2.677 1.979,2.865 0.188,0.188 10 false *1
*1 Battery


Install the bolt.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

NOTICE:
·

Make sure that there is no foreign matter or oil on the compressor shaft, bolt and clutch hub.

·

When reusing the drive belt, check the belt for wear, cracks or other signs of damage.




Hide 2.INSTALL COOLER BRACKET

a.

Connect the ground wire and install the cooler bracket with the screw.


b.

Attach the clamp.


Hide 3.INSPECT MAGNET CLUTCH CLEARANCE

E213814
0.833,3.927 1.354,3.927 1.354,3.927 1.354,4.156 false 3.042,4.177 3.042,3.906 false 1.104,2.344 1.104,1.208 1.104,1.208 1.448,1.208 false 0.094,0.052 0.292,0.24 0.198,0.188 10 false *a 1.49,1.104 1.698,1.281 0.208,0.177 10 false *1 1.292,4.198 1.5,4.375 0.208,0.177 10 false *2 2.99,4.219 3.198,4.396 0.208,0.177 10 false *3
*1 Magnet Clutch Hub
*2 Dial Indicator
*3 Battery
*a Component without harness connected
(Magnet Clutch Assembly)


a.

Clamp the cooler compressor in a vise between aluminum plates.


b.

Set a dial indicator to the magnet clutch hub.


c.

Connect the battery positive (+) lead to terminal 1 of the magnet clutch connector. Turn the magnet clutch on and off by connecting and disconnecting the battery negative (-) lead to and from the ground wire, and measure the clearance.

Standard clearance:

0.25 to 0.50 mm (0.010 to 0.020 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.

Magnet clutch washer thickness:

0.1 mm (0.004 in.)

0.3 mm (0.012 in.)

0.5 mm (0.020 in.)


NOTICE:

Adjustment should be performed with 3 or less magnet clutch washers.



d.

Remove the cooler compressor from the vise.