Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PANEL(for Automatic Air Conditioning System) › 2012.04–2012.10
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052752 AIR CONDITIONING PANEL(for Automatic Air Conditioning System) A

HEATING / AIR CONDITIONING  AIR CONDITIONING PANEL(for Automatic Air Conditioning System)  REMOVAL  


PROCEDURE

Hide 1.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 2.REMOVE INTEGRATION PANEL SUB-ASSEMBLY

a.
E228137

Remove the 4 screws.


b.
E228138

Remove the 4 screws.


c.

Detach the 3 claws and disconnect the lower heater control base.


d.
E228139

Disconnect the No. 1 cooler wire from the integration panel sub-assembly (air conditioning panel) as shown in the illustration.

NOTICE:

Before performing the procedure above, the hazard switch must be turned off. If the switch is on while the base is removed, damage will occur to the switch.