Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) › 2011.10–2012.04
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052762 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

The main power source is supplied to the air conditioning amplifier assembly when the ignition switch is turned to on. The power source is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E227739
0.24,0.406 0.99,0.823 0.75,0.417 10 false from Ignition Switch 2.49,0.594 3.667,0.802 1.177,0.208 10 false ECU-IG&GAUGE 5.375,0.313 5.51,0.479 0.135,0.167 10 false 6 5.531,0.406 5.802,0.563 0.271,0.156 10 false IG+ 5.531,1.094 5.917,1.26 0.385,0.167 10 false GND 5.396,1 5.521,1.156 0.125,0.156 10 false 1 5.208,2.021 5.521,2.208 0.313,0.188 10 false G94 5.208,2.198 6.813,2.583 1.604,0.385 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)
a.
E272301
0.292,1.01 0.719,1.292 0.427,0.281 0.76,1.667 1.177,1.25 true 2.76,1.688 2.333,1.26 true 0.375,1.052 0.833,1.25 0.458,0.198 10 false G94 0.552,1.708 1.01,1.906 0.458,0.198 10 false GND 2.729,1.729 3.188,1.927 0.458,0.198 10 false IG+ 0.115,0.135 0.573,0.333 0.458,0.198 10 false *a
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)


Disconnect the G94 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G94-6 (IG+) - Body ground Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G94-1 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR