Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) › 2011.10–2012.04
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052762 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even after the ignition switch is turned off and is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E227740
0.219,0.938 1.052,1.177 0.833,0.24 10 from Battery 2.854,1.104 3.771,1.281 0.917,0.177 10 ECU-B NO.2 5.25,0.865 5.448,1.073 0.198,0.208 10 5 5.417,0.958 5.813,1.177 0.396,0.219 10 +B1 5.031,1.885 5.365,2.073 0.333,0.188 10 G94 5.052,2.052 6.688,2.542 1.635,0.49 10 Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)
a.
E272301
0.396,1.104 0.813,1.385 0.417,0.281 2.104,1.26 2.677,1.667 true 2.74,1.594 3.052,1.823 0.313,0.229 10 false +B1 0.125,0.083 0.438,0.313 0.313,0.229 10 false *a 0.458,1.156 0.771,1.385 0.313,0.229 10 false G94
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)


Disconnect the G94 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G94-5 (+B1) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR