Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) › 2011.10–2012.04
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052762 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Vehicle Speed Signal Circuit  


DESCRIPTION

The air conditioning amplifier assembly monitors signals from the speedometer sensor via the combination meter. The air conditioning amplifier assembly uses these signals to adjust the thermistor signal.

WIRING DIAGRAM

E235473
1.469,0.438 1.583,0.583 0.115,0.146 10 6 1.458,1.25 1.573,1.396 0.115,0.146 10 5 5.281,0.448 5.458,0.594 0.177,0.146 10 9 5.063,1.781 5.385,1.927 0.323,0.146 10 G94 5.469,0.531 5.917,0.698 0.448,0.167 10 SPD 0.208,1.74 0.542,1.906 0.333,0.167 10 G19 5.063,1.969 6.688,2.365 1.625,0.396 10 Air Conditioning Amplifier Assembly 0.198,1.896 2.135,2.146 1.938,0.25 10 Combination Meter Assembly 1.208,0.563 1.479,0.729 0.271,0.167 10 +S 1.24,1.365 1.51,1.531 0.271,0.167 10 SI 3.302,1.25 4.51,1.604 1.208,0.354 10 from Speedometer Sensor

CAUTION / NOTICE / HINT

HINT:

Check that the speedometer in the combination meter assembly operates normally before inspecting the vehicle speed signal circuit (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>Speed Signal Circuit).


PROCEDURE

1.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
a.
E170958
0.698,0.646 1.115,0.865 0.417,0.219 1.563,2.292 1.24,1.635 true 1.458,2.313 1.792,2.49 0.333,0.177 10 false SPD 2.677,3.667 3.01,3.844 0.333,0.177 10 false GND 0.76,0.677 1.156,0.854 0.396,0.177 10 false G94 0.115,0 0.375,0.229 0.26,0.229 10 false *a 1.063,4.385 2,4.646 0.938,0.26 10 false 20 msec./DIV. 2.573,2.781 3.188,3.031 0.615,0.25 10 false 5 V/DIV.
*a Component with harness connected
(Air Conditioning Amplifier Assembly)


Remove the air conditioning amplifier assembly with its connectors still connected.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for Automatic Air Conditioning System)>REMOVAL


b.

Using an oscilloscope, check the waveform of the air conditioning amplifier assembly.

Measurement Condition:
Item Content
Tester Connection G94-9 (SPD) - Body ground
Tool Setting 5 V/DIV., 20 ms./DIV.
Condition Driving at approximately 20 km/h (12 mph)


OK:

Waveform is as shown in the illustration.


HINT:

As the vehicle speed increases, the wavelength becomes shorter.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - AIR CONDITIONING AMPLIFIER)
2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - AIR CONDITIONING AMPLIFIER)
a.

Disconnect the G19 combination meter assembly connector.


b.

Disconnect the G94 air conditioning amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G19-6 (+S) - G94-9 (SPD) Always Below 1 Ω
G94-9 (SPD) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK COMBINATION METER ASSEMBLY
a.
E224603
1.229,0.563 1.708,0.906 0.479,0.344 2.885,3.646 3.24,3.844 0.354,0.198 10 GND 1.344,0.667 1.646,0.865 0.302,0.198 10 G19 0.292,0.625 0.469,0.823 0.177,0.198 10 *a 2.771,2.552 3.354,2.729 0.583,0.177 10 5V/DIV. 2.219,0.615 2.573,0.813 0.354,0.198 10 +S 1.448,4.365 3.427,4.51 1.979,0.146 10 20 msec./DIV.
*a Component with harness connected
(Combination Meter Assembly)


Remove the combination meter with its connector still connected.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL


b.

Using an oscilloscope, check the waveform of the combination meter assembly.

Measurement Condition:
Item Content
Tester Connection G19-6 (+S) - Body ground
Tool setting 5 V/DIV., 20 ms./DIV.
Condition Driving at approximately 20 km/h (12 mph)


OK:

Waveform is as shown in the illustration.


HINT:

As the vehicle speed increases, the wavelength becomes shorter.



Result:
Proceed to
OK
NG



OK

NG

REPLACE COMBINATION METER ASSEMBLY