Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 2TR-FE) › from 2012.10
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052764 COMPRESSOR(for 2TR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2TR-FE)  INSTALLATION  


PROCEDURE

Hide 1.ADJUST COMPRESSOR OIL

a.

When replacing the compressor with a new one after gradually releasing the refrigerant gas from the service valve, drain the following amount of oil from the new compressor before installation.

Standard:

(Oil capacity inside new compressor: 80 + 15 cc (2.7 + 0.5 fl. oz)) - (Remaining oil amount in the removed compressor) = (Oil amount to be removed when replacing)


NOTICE:
·

When checking the compressor oil level, follow the A/C system's precautions.

·

Since compressor oil remains in the pipes of the vehicle, if a new compressor is installed without removing some oil inside, the oil amount becomes excessive. Excessive oil prevents heat exchange in the refrigerant cycle and causes refrigerant failure.

·

If the remaining oil in the removed compressor is too low, check for oil leakage.

·

Be sure to use ND-OIL 8 for compressor oil.




Hide 2.INSTALL COOLER COMPRESSOR ASSEMBLY

E271948
1.073,0.115 1.229,0.313 0.156,0.198 10 false 1 1.771,1.125 1.927,1.323 0.156,0.198 10 false 2 1.083,1.125 1.24,1.323 0.156,0.198 10 false 3 2.406,0.073 2.563,0.271 0.156,0.198 10 false 4

a.

Install the cooler compressor assembly with the 4 bolts and tighten the bolts in the order shown in the illustration.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)


b.

Connect the connector.


Hide 3.INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the vinyl tape attached to the No. 1 cooler refrigerant discharge hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the No. 1 cooler refrigerant discharge hose.


d.

Connect the No. 1 cooler refrigerant discharge hose with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 4.INSTALL SUCTION HOSE SUB-ASSEMBLY

a.

Remove the vinyl tape attached to the suction hose sub-assembly.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the suction hose sub-assembly.


d.

Connect the suction hose sub-assembly with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)