Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 2TR-FE)
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052764 COMPRESSOR(for 2TR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2TR-FE)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE COOLER BRACKET

E225741

a.

Detach the clamp.


b.

Remove the screw and cooler bracket.


Hide 2.REMOVE MAGNET CLUTCH ASSEMBLY

E213723
1.854,2.833 2.396,2.833 false 1.677,2.74 1.854,2.917 0.177,0.177 10 false *1
*1 Battery


a.

Clamp the cooler compressor in a vise between aluminum plates.


b.

Connect the battery to the magnet clutch assembly as shown in the illustration to fix the hub and rotor in place.


c.

Wrap the drive belt around the rotor and securely hold it in place by hand.


d.

Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.



e.
E155202

Using a snap ring expander, remove the snap ring and magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.



f.
E155203

Using a snap ring expander, remove the snap ring and magnet clutch stator.