1.INSTALL COOLER DRYER
| *1 | Modulator |
Using pliers, install a new cooler dryer to the modulator.
Apply sufficient compressor oil to a new O-ring and the cap fitting surface.
ND-OIL 8 or equivalent
Using a 14 mm straight hexagon wrench, install the cap to the cooler condenser core.
2.INSTALL NO. 3 COOLER CONDENSER BRACKET
Install the No. 3 cooler condenser bracket with the 2 bolts.
3.INSTALL NO. 2 COOLER CONDENSER BRACKET
Install the No. 2 cooler condenser bracket with the 2 bolts.
4.INSTALL NO. 1 COOLER CONDENSER BRACKET
Use the same procedure for both No. 1 cooler condenser brackets.
Install the No. 1cooler condenser bracket with the 2 bolts.