Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1GR-FE) › from 2012.04
RM1840EF _58 Vehicle Interior _009648 HEATING / AIR CONDITIONING _0052766 COMPRESSOR(for 1GR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1GR-FE)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL MAGNET CLUTCH ASSEMBLY

E171833

a.

Install the magnet clutch stator with the parts aligned as shown in the illustration.


b.
I032461

Using a snap ring expander, install a new snap ring with the chamfered side facing outward.


c.

Attach the connector clamp.


d.
I031582

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



e.

Install the magnet clutch washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of magnet clutch washer(s) used before disassembly.



f.
E174575
0.594,1.521 1.667,1.521 true 0.219,1.438 0.552,1.646 0.333,0.208 10 false SST

Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00260  

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



Hide 2.INSTALL COOLER BRACKET

E174572

a.

Install the cooler bracket with the screw.


Hide 3.INSPECT MAGNET CLUTCH CLEARANCE

E174574
1.646,4.135 2.604,4.135 false 1.469,4.042 1.646,4.229 0.177,0.188 10 false *1 0.115,0.073 0.333,0.271 0.219,0.198 10 false *a
*1 Battery
*a Component without harness connected
(Magnet Clutch Assembly)


a.

Clamp the cooler compressor in a vise between aluminum plates.


b.

Set a dial indicator to the magnet clutch hub.


c.

Connect the battery positive (+) lead to terminal 1 of the magnet clutch connector. Turn the magnet clutch on and off by connecting and disconnecting the battery negative (-) lead to and from the ground wire, and measure the clearance.

Standard clearance:

0.35 to 0.60 mm (0.014 to 0.024 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.

Magnet clutch washer thickness:

0.1 mm (0.004 in.)

0.3 mm (0.012 in.)

0.5 mm (0.020 in.)


NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



d.

Remove the cooler compressor from the vise.