1.REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY
Remove the 2 screws and console compartment door.
2.REMOVE REAR CONSOLE END PANE SUB-ASSEMBLY (w/ Cup Holder)
Remove the 4 screws and rear console end panel.
3.REMOVE REAR NO. 2 BOX PANEL (w/o Cup Holder)
Remove the 2 screws.
Detach the 2 claws and 2 guides and remove the rear No. 2 box panel.
4.REMOVE CONSOLE BOX BEZEL (for Manual Transmission, for 2WD)
Remove the 4 screws.
Detach the 4 claws and remove the shifting hole cover.
Detach the 8 claws and remove the console box bezel.
5.REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Automatic Transmission, for 4WD)
Detach the 7 claws and remove the shifting hole cover.