Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) › 2011.10–2012.04
RM1840EF _59 Vehicle Exterior _009651 WINDOW / GLASS _0052778 POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)  Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)  


DESCRIPTION

If the door glass or the front power window regulator motor assembly LH does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.

HINT:

The jam protection function is only available on the driver side power window.


PROCEDURE

1.RESET FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
a.

Reset the front power window regulator motor assembly LH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION


b.

Check that the power window auto up/down function operates normally.

OK:

Auto up/down function operates normally.



Result:
Prpceed to
OK
NG



OK

END (PROBLEM DUE TO RESET FAILURE)

NG

2.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
2.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
a.

Remove the installation bolt of the door glass and hold the glass by hand. When raising the glass by hand, check that the glass moves smoothly.

NOTICE:
·

Make sure that the glass run is not deformed, and that there is no foreign matter on the glass run.

·

Make sure that the glass run does not have foreign matter attached to it.



OK:

Window glass slides smoothly.



Result:
Proceed to
OK
NG



OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NG

INSTALL DOOR GLASS AND/OR GLASS RUN PROPERLY (APPLICABLE LOCATION)