Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SWITCH(for Manual Cooler System)
RM1840EF _59 Vehicle Exterior _009651 WINDOW / GLASS _0052780 WINDOW DEFOGGER SWITCH(for Manual Cooler System) G

WINDOW / GLASS  WINDOW DEFOGGER SWITCH(for Manual Cooler System)  INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR WINDOW DEFOGGER SWITCH ASSEMBLY

B280808
1.969,2.792 2.271,3.021 2.271,3.021 2.458,3.021 true 2.156,2.625 2.458,2.396 2.458,2.396 2.646,2.396 true 1.563,1.042 0.979,1.042 false 2.521,2.917 2.854,3.083 0.333,0.167 10 false ILL- 2.708,2.302 3.042,2.469 0.333,0.167 10 false ILL+ 0.135,1.771 0.375,1.979 0.24,0.208 10 false *a 0.76,0.938 1,1.146 0.24,0.208 10 false *b
*a Component without harness connected
(Rear Window Defogger Switch Assembly)
*b Illumination Area


a.

Check the illumination area of the switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 1 (ILL+)
Battery negative (-) → 2 (ILL+)
Illuminates


If the result is not as specified, replace the rear window defogger switch assembly.

HINT:

The on/off indicator of the switch will not illuminate.



b.
B280809
1.74,2.792 1.958,3.167 1.958,3.167 2.083,3.167 true 1.323,2.792 1.104,3.167 1.104,3.167 0.979,3.167 true 1.594,0.698 1.063,0.698 false 0.781,3.063 0.969,3.229 0.188,0.167 10 false IG 2.146,3.073 2.313,3.24 0.167,0.167 10 false E 0.156,1.698 0.396,1.906 0.24,0.208 10 false *a 0.885,0.573 1.125,0.781 0.24,0.208 10 false *b
*a Component without harness connected
(Rear Window Defogger Switch Assembly)
*b On/off Indicator


Check the on/off indicator of the switch.

i.

Push the switch several times. Check that the on/off indicator illuminates or turns off according to the switch operation.

OK:
Measurement Condition Specified Condition Specified Condition
Battery positive (+) → 5 (IG)
Battery negative (-) → 3 (E)
Defogger switch on Illuminates


If the result is not as specified, replace the rear window defogger switch assembly.

HINT:

The illumination area of the switch will not illuminate.




c.
B154298
1.719,1.438 2.073,0.583 2.073,0.583 2.281,0.583 true 1.49,1.448 1.135,0.594 1.135,0.594 0.927,0.594 true 0.771,0.5 0.927,0.667 0.156,0.167 10 false D 2.354,0.49 2.521,0.656 0.167,0.167 10 false E 0.094,0.031 0.333,0.24 0.24,0.208 10 false *a
*a Component without harness connected
(Rear Window Defogger Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Measurement Condition Switch Condition Specified Condition
4 (D) - 3 (E) on Below 1 Ω
4 (D) - 3 (E) off 10 kΩ or higher


If the result is not as specified, replace the rear window defogger switch assembly.