Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Apply MP grease to the sliding and rotating areas of the regulator motor assembly LH.
Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws.
2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
5.INSTALL REAR DOOR GLASS RUN LH
6.INSTALL REAR DOOR SERVICE HOLE COVER LH
7.INSTALL REAR DOOR NO. 2 TRIM BRACKET
8.INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH
9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
10.INSTALL DOOR PULL HANDLE
11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL LH
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).