Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL LH
4.REMOVE DOOR PULL HANDLE
5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
6.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH
7.REMOVE REAR DOOR NO. 2 TRIM BRACKET
8.REMOVE REAR DOOR SERVICE HOLE COVER LH
9.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
10.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
11.REMOVE REAR DOOR GLASS RUN LH
12.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
13.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.