Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM1840EF _59 Vehicle Exterior _009652 DOOR / HATCH _0052797 HOOD A

DOOR / HATCH  HOOD  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL HOOD BUMPER CUSHION

HINT:

Use the same procedure for both hood bumper cushions.


a.

Install a new hood bumper cushion.


Hide 2.INSTALL WASHER HOSE ASSEMBLY

a.
B342441
0.646,1.438 0.708,1.177 0.708,1.177 0.813,1.177 true 1.396,1.302 1.396,1.625 1.396,1.625 1.563,1.625 true 2.146,0.927 2.146,0.74 2.146,0.74 2,0.74 false 2.885,0.865 2.885,0.594 2.885,0.594 2.76,0.594 true 2.75,1.24 2.75,1.865 2.75,1.865 2.594,1.865 true 0.844,1.073 1.156,1.229 0.313,0.156 10 false *1 1.813,0.656 2.125,0.813 0.313,0.156 10 false *2 1.625,1.51 1.938,1.667 0.313,0.156 10 false *1 2.542,0.51 2.854,0.667 0.313,0.156 10 false *1 2.406,1.771 2.719,1.927 0.313,0.156 10 false *1
*1 Clamp
*2 Hanger


Attach the 4 clamps to connect the washer hose to the hanger.


Hide 3.INSTALL WASHER NOZZLE SUB-ASSEMBLY

Hide 4.INSTALL NO. 1 HOOD BULGE PROTECTOR (w/ Intercooler)

HINT:

When installing the No. 1 hood bulge protector, heat the hood bulge surface using a heat light.


Standard:
Item Temperature
Hood Bulge 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the hood bulge excessively.


a.

Clean the hood bulge surface.

i.

Using a heat light, heat the hood bulge surface.


ii.

Remove the double-sided tape from the hood bulge surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B278369

Install a new No. 1 hood bulge protector to the hood bulge as shown in the illustration.


Hide 5.INSTALL HOOD BULGE (w/ Intercooler)

a.

Install the hood bulge with the 10 nuts.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 6.INSTALL HOOD AIR INTAKE SEAL (w/ Intercooler)

a.

Install the hood air intake seal with the 18 clips.


Hide 7.INSTALL HOOD INSULATOR (w/ Hood Insulator)

a.
B277306
0.052,0.063 0.323,0.26 0.271,0.198 10 false *A 0.073,1.688 0.427,1.906 0.354,0.219 10 false *B
*A w/o Intercooler
*B w/ Intercooler


Install the hood insulator with the 15 clips.


Hide 8.INSTALL HOOD TO RADIATOR SUPPORT SEAL

a.

Attach the 6 clips to install the hood to radiator support seal.