1.REMOVE TAIL GATE SERVICE HOLE COVER
| *A | for A Deck |
| *B | for J Deck |
for A Deck:
Remove the 10 screws and tail gate service hole cover.
for J Deck:
Remove the 8 screws and tail gate service hole cover.
2.REMOVE CENTER STOP LIGHT ASSEMBLY (w/ Center Stop Light)
3.REMOVE BACK DOOR NO. 2 OUTSIDE GARNISH (w/ Rear View Monitor System)
4.REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)
5.REMOVE TAIL GATE LOCK CONTROL LINK LH (for A Deck)
| *1 | Control Link Snap |
Rotate the control link snaps in the directions indicated by the arrows in the illustration and detach the control link snaps from the tail gate lock control link.
Remove the tail gate lock control link.
6.REMOVE TAIL GATE LOCK CONTROL LINK RH (for A Deck)
Use the same procedure described for the LH side.
7.REMOVE TAIL GATE HANDLE ASSEMBLY (for A Deck)
Remove the 2 bolts and tail gate handle.
8.REMOVE TAIL GATE LOCK ASSEMBLY LH (for A Deck)
Remove the 2 bolts and tail gate lock.
9.REMOVE TAIL GATE LOCK ASSEMBLY RH (for A Deck)
Use the same procedure described for the LH side.
10.REMOVE TAIL GATE STAY STOPPER (for A Deck)
Use the same procedure for both tail gate stay stoppers.
Remove the bolt and tail gate stay stopper.
11.REMOVE REAR BODY TAIL GATE LATCH ASSEMBLY (for J Deck)
Use the same procedure for both rear body tail gate latches.
Remove the 2 bolts and rear body tail gate latch.
12.REMOVE TAIL GATE HINGE ASSEMBLY LH
| *1 | "TORX" Bolt |
| *2 | Bolt |
Using a T40 "TORX" socket wrench, remove the 2 "TORX" bolts.
Remove the bolt and tail gate hinge.
13.REMOVE TAIL GATE HINGE ASSEMBLY RH
Use the same procedure described for the LH side.