1.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Disconnect the mirror connector.
Apply battery voltage and check operation of the mirror.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) →Terminal 9 (MV)
Battery negative (-) → Terminal 8 (M+) |
Turns upward |
| Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 9 (MV) |
Turns downward |
| Battery positive (+) → Terminal 4 (MH)
Battery negative (-) → Terminal 8 (M+) |
Turns left |
| Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 4 (MH) |
Turns right |
If the result is not as specified, replace the outer rear view mirror assembly LH.
w/ Side Turn Signal Light:
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Check the side turn signal light assembly.
Apply battery voltage to the terminals of the connector, and check the illumination condition.
| Tester Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 10 (TRNL)
Battery negative (-) → Terminal 6 (GND) |
Side turn signal light illuminates |
If the result is not as specified, replace the side turn light assembly.
2.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH
| *a | Component without harness connected
(Outer Rear View Mirror Assembly RH) |
Disconnect the mirror connector.
Apply battery voltage and check operation of the mirror.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) →Terminal 9 (MV)
Battery negative (-) → Terminal 8 (M+) |
Turns upward |
| Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 9 (MV) |
Turns downward |
| Battery positive (+) → Terminal 4 (MH)
Battery negative (-) → Terminal 8 (M+) |
Turns left |
| Battery positive (+) → Terminal 8 (M+)
Battery negative (-) → Terminal 4 (MH) |
Turns right |
If the result is not as specified, replace the outer rear view mirror assembly RH.
w/ Side Turn Signal Light:
| *a | Component without harness connected
(Outer Rear View Mirror Assembly RH) |
Check the side turn signal light assembly.
Apply battery voltage to the terminals of the connector, and check the illumination condition.
| Tester Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 10 (TRNR)
Battery negative (-) → Terminal 6 (GND) |
Side turn signal light illuminates |
If the result is not as specified, replace the side turn signal light assembly.