Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH (w/ Power Window)
2.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (w/ Power Window, for Front Passenger Side)
Using a moulding remover D, detach the 2 clips and 4 claws and remove the power window regulator switch assembly with front door armrest base panel.
Disconnect the connector.
3.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
| *1 | Protective Tape |
Insert a clip remover between the plate and trim board.
Tape the clip remover tip before use.
Turn the handle counterclockwise to remove the snap ring, front door window regulator handle and plate.
4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
| *A | w/o Front No. 2 Speaker |
| *B | w/ Front No. 2 Speaker |
Detach the 2 clips and remove the front door lower frame bracket garnish LH.
5.REMOVE DOOR PULL HANDLE
Remove the screw and door pull handle.
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
| *1 | Clip |
| *2 | Screw |
for Double Cab:
Remove the clip and screw.
Detach the 8 clips and remove the front door trim board sub-assembly LH.
| *1 | Clip |
| *2 | Screw |
for Single Cab:
Remove the clip and screw.
Detach the 9 clips and remove the front door trim board sub-assembly LH.
7.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
w/ Power Mirror Control System:
Disconnect the mirror connector.
Remove the 3 nuts.
Push down the claw and remove the outer rear view mirror assembly LH.