Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR › 2012.04–2012.10
RM1840EF _59 Vehicle Exterior _009653 MIRROR (EXT) _0052804 OUTER REAR VIEW MIRROR A

MIRROR (EXT)  OUTER REAR VIEW MIRROR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH (w/ Power Window)

Hide 2.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (w/ Power Window, for Front Passenger Side)

B284004

a.

Using a moulding remover D, detach the 2 clips and 4 claws and remove the power window regulator switch assembly with front door armrest base panel.


b.

Disconnect the connector.


Hide 3.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

a.
B277021
1.042,1.375 0.813,1.594 0.813,1.594 0.573,1.594 false 0.396,1.5 0.625,1.677 0.229,0.177 10 *1
*1 Protective Tape


Insert a clip remover between the plate and trim board.

HINT:

Tape the clip remover tip before use.



b.

Turn the handle counterclockwise to remove the snap ring, front door window regulator handle and plate.


Hide 4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

a.
B277018
0.065,0.0 0.287,0.218 0.222,0.218 10 *A 0.065,1.516 0.287,1.734 0.222,0.218 10 *B
*A w/o Front No. 2 Speaker
*B w/ Front No. 2 Speaker


Detach the 2 clips and remove the front door lower frame bracket garnish LH.


Hide 5.REMOVE DOOR PULL HANDLE

a.
B277022

Remove the screw and door pull handle.


Hide 6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

a.
B277024
3.188,1.073 3.188,0.948 false 3.188,1.688 3.188,1.573 false 3.104,1.094 3.323,1.271 0.219,0.177 10 *1 3.104,1.719 3.344,1.896 0.24,0.177 10 *2
*1 Clip
*2 Screw


for Double Cab:

i.

Remove the clip and screw.


ii.

Detach the 8 clips and remove the front door trim board sub-assembly LH.



b.
B277023
3.115,0.927 3.115,1.104 false 3.135,1.542 3.135,1.719 false 3.021,1.104 3.271,1.26 0.25,0.156 10 *1 3.063,1.74 3.323,1.885 0.26,0.146 10 *2
*1 Clip
*2 Screw


for Single Cab:

i.

Remove the clip and screw.


ii.

Detach the 9 clips and remove the front door trim board sub-assembly LH.



Hide 7.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

B342047

a.

w/ Power Mirror Control System:

Disconnect the mirror connector.


b.

Remove the 3 nuts.


c.

Push down the claw and remove the outer rear view mirror assembly LH.