Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR COVER › from 2012.10
RM1840EF _59 Vehicle Exterior _009653 MIRROR (EXT) _0052806 OUTER REAR VIEW MIRROR COVER A

MIRROR (EXT)  OUTER REAR VIEW MIRROR COVER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL OUTER MIRROR COVER LH

a.

Attach the 2 claws as shown in the illustration.

B342057


b.

Attach the 6 claws to install the outer mirror cover LH.


c.
B278385

After installing the outer mirror cover, check that there is no gap between the cover and mirror body.

If there is a gap between the cover and body, noise will occur during driving.


d.
B278444
1.438,0.24 1.313,0.344 1.313,0.344 1.063,0.344 false 0.917,1.521 0.917,1.719 false 2.573,1.792 2.5,1.948 2.5,1.948 2.354,1.948 false 0.865,0.24 1.146,0.438 0.281,0.198 10 false *1 0.833,1.74 1.094,1.948 0.26,0.208 10 false *1 2.188,1.854 2.448,2.042 0.26,0.188 10 false *1
*1 Adhesive


Using a T25 "TORX" socket wrench, install the screws.

HINT:
·

Clean the threads of the screws with non-residue solvent.

·

Apply adhesive to the threads of the screws.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent





e.

Attach the 5 claws.


f.

Install the rubber base with the screw.


g.
B278446
1.146,1.229 1.271,1.594 1.271,1.594 1.531,1.594 false 1.021,0.406 1.302,0.594 0.281,0.188 10 false *a 1.583,1.51 1.896,1.698 0.313,0.188 10 false *1
*1 Tape
*a 40 mm (1.58 in.)


Apply new tape as shown in the illustration.


Hide 3.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

a.

Install the outer rear view mirror assembly LH (See page Vehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSTALLATION).