Home › Vehicle Exterior › MIRROR (EXT) › OUTER MIRROR SWITCH › 2011.10–2014.04
RM1840EF _59 Vehicle Exterior _009653 MIRROR (EXT) _0052807 OUTER MIRROR SWITCH G

MIRROR (EXT)  OUTER MIRROR SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT OUTER MIRROR SWITCH ASSEMBLY

B203252
1.385,3.677 0.813,4.083 false 1.604,3.698 1.396,4.094 false 1.74,3.708 1.781,4.104 false 1.885,3.688 2.25,4.094 false 1.479,3.698 1.083,4.094 false 2.01,3.688 2.646,4.094 false 2.115,3.688 3.167,4.083 false 2.271,3.615 2.833,3.25 false 1.115,3.615 0.76,3.271 0.76,3.271 1.271,3.594 false 2.104,0.917 2.563,0.917 false 0.24,2.219 0.531,2.385 0.292,0.167 10 *a 2.573,0.823 2.823,1 0.25,0.177 10 *1 0.729,4.104 0.938,4.25 0.208,0.146 10 B 1.26,4.104 1.542,4.26 0.281,0.156 10 M+ 1,4.104 1.219,4.25 0.219,0.146 10 E 1.573,4.104 1.969,4.281 0.396,0.177 10 MLH 2.063,4.104 2.479,4.26 0.417,0.156 10 MLV 2.49,4.104 2.896,4.292 0.406,0.188 10 MRV 3,4.104 3.406,4.271 0.406,0.167 10 MRH 2.875,3.156 3.385,3.313 0.51,0.156 10 No Pin 0.25,3.177 0.771,3.354 0.521,0.177 10 No Pin
*1 Select Switch
*a Component without harness connected
(Outer Mirror Switch Assembly)


a.

Inspect the outer mirror switch.

i.

Select "L" on the select switch.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (MLV) - 8 (B)
6 (M+) - 7 (E)
UP Pressed Below 1 Ω
Not pressed 10 kΩ or higher
4 (MLV) - 7 (E)
6 (M+) - 8 (B)
DOWN Pressed Below 1 Ω
Not pressed 10 kΩ or higher
5 (MLH) - 8 (B)
6 (M+) - 7 (E)
LEFT Pressed Below 1 Ω
Not pressed 10 kΩ or higher
5 (MLH) - 7 (E)
6 (M+) - 8 (B)
RIGHT Pressed Below 1 Ω
Not pressed 10 kΩ or higher


If the result is not as specified, replace the outer mirror switch assembly.


iii.

Select "R" on the select switch.


iv.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (MRV) - 8 (B)
6 (M+) - 7 (E)
UP Pressed Below 1 Ω
Not pressed 10 kΩ or higher
3 (MRV) - 7 (E)
6 (M+) - 8 (B)
DOWN Pressed Below 1 Ω
Not pressed 10 kΩ or higher
2 (MRH) - 8 (B)
6 (M+) - 7 (E)
LEFT Pressed Below 1 Ω
Not pressed 10 kΩ or higher
2 (MRH) - 7 (E)
6 (M+) - 8 (B)
RIGHT Pressed Below 1 Ω
Not pressed 10 kΩ or higher


If the result is not as specified, replace the outer mirror switch assembly.