Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR › 2012.04–2012.10
RM1840EF _59 Vehicle Exterior _009654 WIPER / WASHER _0052809 FRONT WIPER MOTOR A

WIPER / WASHER  FRONT WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT WIPER ARM HEAD CAP

a.
E225502

Using a screwdriver, remove the front wiper arm head cap.

HINT:
·

Tape the screwdriver tip before use.

·

Use the same procedure for both front wiper arm head caps.




Hide 4.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

a.
E225271

Remove the nut and the front wiper arm and blade assembly LH.


Hide 5.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

a.
E225272

Remove the nut and the front wiper arm and blade assembly RH.


Hide 6.REMOVE HOOD TO COWL TOP SEAL

a.
E225273

Using a clip remover, detach the 9 clips and remove the hood to cowl top seal.


Hide 7.REMOVE COWL TOP VENTILATOR LOUVER RH

a.
E225275

Remove the clip.


b.

Detach the 5 claws and 5 guides, and remove the cowl top ventilator louver RH in the direction indicated by the arrow in the illustration.


Hide 8.REMOVE COWL TOP VENTILATOR LOUVER LH

a.
E225274

Remove the clip.


b.

Detach the 5 guides, and remove the cowl top ventilator louver LH in the direction indicated by the arrow in the illustration.


Hide 9.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

a.
E225276

Disconnect the connector.


b.

Remove the 2 bolts.


c.

Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the windshield wiper motor and link.


Hide 10.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a.
E225277

Using a screwdriver, disconnect the 2 rods of the wiper link from the windshield wiper motor as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



b.
E225278

Using a T30 "TORX" socket, remove the 2 bolts and windshield wiper motor.