Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR › 2011.10–2012.01
RM1840EF _59 Vehicle Exterior _009654 WIPER / WASHER _0052809 FRONT WIPER MOTOR G

WIPER / WASHER  FRONT WIPER MOTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT WINDSHIELD WIPER LINK ASSEMBLY

a.
E225279
2.385,0 2.594,0.156 0.208,0.156 10 false A 2.51,1.802 2.719,1.979 0.208,0.177 10 false B 2.656,0.74 2.875,0.958 0.219,0.219 10 false C 0.208,1.115 0.417,1.323 0.208,0.208 10 false D 1.854,0.76 2.042,0.948 0.188,0.188 10 true E

Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and the wipers do not come into contact with the vehicle body.

Standard:
Area Standard Condition
A 25.0 mm (0.984 in.)
B 30.4 mm (1.19 in.)
C 24.3 mm (0.956 in.)
D 24.7 mm (0.972 in.)
E 19.0 mm (0.748 in.)



b.

Stop the front wiper motor and link assembly operation.


c.
E225280
0.781,1.938 0.781,2.104 false 2.802,4.156 2.802,4.344 false 0.063,0.052 0.281,0.219 0.219,0.167 10 false *A 0.073,2.469 0.281,2.656 0.208,0.188 10 false *B 0.698,2.115 0.875,2.281 0.177,0.167 10 false *1 2.719,4.354 2.896,4.521 0.177,0.167 10 false *1 1.198,2.073 1.438,2.302 0.24,0.229 10 false A 2.656,2.073 2.865,2.292 0.208,0.219 10 false B 0.281,4.198 0.427,4.344 0.146,0.146 10 false C 2.198,4.323 2.333,4.469 0.135,0.146 10 false D
*A for LH Side
*B for RH Side
*1 Louver Edge


Check the automatic stop position.

OK:

The front wipers stop at the positions shown in the illustration.


Standard:
Area Standard Condition
A 25 mm (0.984 in.)
B 33 mm (1.29 in.)
C 25 mm (0.984 in.)
D 25 mm (0.984 in.)


If the result is not as specified, remove and reinstall the wiper arm and blade assembly, and perform the on-vehicle inspection described above to inspect the wiper motor and link assembly again.

If the result is not as specified again, inspect the wiper motor and link assembly with it removed from the vehicle body (See page Vehicle Exterior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).