Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › from 2012.04
RM1840EF _59 Vehicle Exterior _009654 WIPER / WASHER _0052811 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

a.

Attach the claw to install the windshield wiper switch assembly.

NOTICE:

Do not push the claw with excessive force as damage may occur.



b.

Connect the connectors.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).