Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM1840EF _59 Vehicle Exterior _009655 LIGHTING (EXT) _0052814 LIGHTING SYSTEM U

LIGHTING (EXT)  LIGHTING SYSTEM  TERMINALS OF ECU  


CHECK AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)


E225438
3.323,0.125 3.792,0.396 0.469,0.271 3.427,0.177 3.833,0.396 0.406,0.219 10 false G96

a.

Disconnect the G96 automatic light control sensor connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G96-1 (IG) - Body ground R-L - Body ground Ignition power supply Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
G96-2 (B) - Body ground L-Y - Body ground Battery power supply Always 11 to 14 V
G96-5 (H) - Body ground GR - Body ground H-LP relay signal input Headlight dimmer switch in HEAD position Below 1 V
Headlight dimmer switch not in HEAD position 11 to 14 V
G96-7 (T) - Body ground LG-B - Body ground Taillight relay signal input Headlight dimmer switch in TAIL position Below 1 V
Headlight dimmer switch not in TAIL position 11 to 14 V
G96-6 (A) - Body ground P-L - Body ground Ground Headlight dimmer switch in AUTO position Below 1 Ω
Headlight dimmer switch not in AUTO position 10 kΩ or higher

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the G96 automatic light control sensor connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G96-3 (CTY) - Body ground R-B - Body ground Front door courtesy light switch LH signal input Front door LH open Below 1 V
Front door LH closed 11 to 14 V
G96-5 (H) - Body ground GR - Body ground H-LP relay drive output Ignition switch ON
Headlight dimmer switch in AUTO position
Automatic light control sensor covered with a hand
Low beam headlights come on
Below 1 V
Ignition switch ON
Headlight dimmer switch in AUTO position
Automatic light control sensor exposed to ambient light
Low beam headlights turn off
11 to 14 V
G96-7 (T) - Body ground LG-B - Body ground Taillight relay drive output Ignition switch ON
Headlight dimmer switch in AUTO position
Automatic light control sensor covered with a hand
Taillights come on
Below 1 V
Ignition switch ON
Headlight dimmer switch in AUTO position
Automatic light control sensor exposed to ambient light
Taillights turn off
11 to 14 V

If the result is not as specified, the automatic light control sensor may have a malfunction.