Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM1840EF _59 Vehicle Exterior _009655 LIGHTING (EXT) _0052824 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

E065594
0.125,1.021 0.344,0.75 true 2.563,0.333 2.802,0.729 true 2.948,0.729 3.156,0.333 true 3.115,0.167 3.385,0.417 0.271,0.25 10 1 2.51,0.177 2.813,0.427 0.302,0.25 10 2 0.115,0.094 0.375,0.375 0.26,0.281 10 *a 0.083,1.521 0.417,1.792 0.333,0.271 10 *b 0.042,1.042 0.333,1.333 0.292,0.292 10 *1 0.667,1.531 1,1.844 0.333,0.313 10 *c
*1 Shaft
*a Component without harness connected (Stop Light Switch Assembly)
*b Not Pushed
*c Pushed


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 Shaft not pushed Below 1 Ω
Shaft pushed 10 kΩ or higher


If the result is not as specified, replace the stop light switch assembly.