Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY
RM1840EF _59 Vehicle Exterior _009655 LIGHTING (EXT) _0052825 TURN SIGNAL FLASHER ASSEMBLY G

LIGHTING (EXT)  TURN SIGNAL FLASHER ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK TURN SIGNAL FLASHER ASSEMBLY

a.
E162022
2.333,1.75 2.76,1.406 true 2.052,1.74 2.771,0.917 true 1.125,1.75 0.646,0.792 true 1.104,2.063 0.698,2.115 true 1.521,2.208 1.323,2.656 true 1.792,2.219 2.094,2.708 true 2.052,2.208 2.552,2.667 true 2.344,2.115 2.844,2.344 true 0.125,0.083 2.521,0.552 2.396,0.469 10 false *a 2.802,1.302 3.073,1.563 0.271,0.26 10 false IG 2.813,0.75 3.146,1.052 0.333,0.302 10 false LR 0.479,0.594 0.802,0.833 0.323,0.24 10 false LL 2.865,2.271 3.156,2.531 0.292,0.26 10 false B 2.521,2.698 2.896,2.948 0.375,0.25 10 false EL 2.042,2.75 2.375,3.042 0.333,0.292 10 false ER 1.229,2.698 1.479,2.969 0.25,0.271 10 false E 0.406,2.031 0.813,2.292 0.406,0.26 10 false HAZ
*a Front view of wire harness connector (to Turn Signal Flasher Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (E) - Body ground Always Below 1 Ω



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (LR) - 7 (E) Hazard warning switch off Below 1 V
Hazard warning switch on Alternating between 11 to 14 V and below 1 V
(60 to 120 times per minute)
3 (LL) - 7 (E) Hazard warning switch off Below 1 V
Hazard warning switch on Alternating between 11 to 14 V and below 1 V
(60 to 120 times per minute)
4 (B) - 7 (E) Always 11 to 14 V
5 (EL) - 7 (E) Ignition switch ON
Headlight dimmer switch (turn left) off
9 V or higher
Ignition switch ON
Headlight dimmer switch (turn left) on
Below 1 V
6 (ER) - 7 (E) Ignition switch ON
Headlight dimmer switch (turn right) off
9 V or higher
Ignition switch ON
Headlight dimmer switch (turn right) on
Below 1 V
8 (HAZ) - 7 (E) Hazard warning switch off 9 V or higher
Hazard warning switch on Below 1 V


If the result is not as specified, there may be a malfunction in the turn signal flasher.