Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2011.10–2012.10
RM1840EF _59 Vehicle Exterior _009657 EXTERIOR PANELS / TRIM _0052831 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 1.INSTALL FRONT BUMPER SIDE SUPPORT LH

a.

Attach the 2 claws to install the front bumper side support.


b.

Install the bolt and screw.


Hide 2.INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure described for the LH side.


Hide 3.INSTALL NO. 2 FRONT BUMPER RETAINER BRACKET

a.

Install the No. 2 front bumper retainer bracket with the bolt.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 4.INSTALL NO. 1 FRONT BUMPER RETAINER BRACKET

HINT:

Use the same procedure described for the No. 2 front bumper retainer bracket.


Hide 5.INSTALL RADIATOR SIDE DEFLECTOR LH

a.

Attach the claw to install the radiator side deflector.


b.

Install the 3 clips.


Hide 6.INSTALL RADIATOR SIDE DEFLECTOR RH

HINT:

Use the same procedure described for the LH side.


Hide 7.INSTALL FRONT BUMPER MOUNTING BRACKET

HINT:

Use the same procedure for both front bumper mounting brackets.


a.

Install the front bumper mounting bracket with the bolt.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 8.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

a.

Install the front bumper reinforcement with the 4 nuts.

Torque:
67 N*m (683 kgf*cm, 49 ft.*lbf)


Hide 9.INSTALL FRONT BUMPER REINFORCEMENT EXTENSION LH

a.

Attach the 2 claws to install the front bumper reinforcement extension.


Hide 10.INSTALL FRONT BUMPER REINFORCEMENT EXTENSION RH

HINT:

Use the same procedure described for the LH side.


Hide 11.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH

a.

Install the engine side cover with the 3 bolts and 2 clips.

Torque:
12 N*m (117 kgf*cm, 8 ft.*lbf)


Hide 12.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 13.INSTALL FRONT BUMPER COVER

a.

w/ Fog Light:

Connect the 2 fog light connectors.


b.

Attach the 6 claws to install the front bumper cover.


c.

Install the 5 clips, 2 bolts and 2 screws.


d.

Install the 3 clips and 6 screws.


Hide 15.ADJUST FOG LIGHT AIMING (w/ Fog Light)