A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL FRONT BUMPER SIDE SUPPORT LH
Attach the 2 claws to install the front bumper side support.
Install the bolt and screw.
2.INSTALL FRONT BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
3.INSTALL NO. 2 FRONT BUMPER RETAINER BRACKET
Install the No. 2 front bumper retainer bracket with the bolt.
4.INSTALL NO. 1 FRONT BUMPER RETAINER BRACKET
Use the same procedure described for the No. 2 front bumper retainer bracket.
5.INSTALL RADIATOR SIDE DEFLECTOR LH
Attach the claw to install the radiator side deflector.
Install the 3 clips.
6.INSTALL RADIATOR SIDE DEFLECTOR RH
Use the same procedure described for the LH side.
7.INSTALL FRONT BUMPER MOUNTING BRACKET
Use the same procedure for both front bumper mounting brackets.
Install the front bumper mounting bracket with the bolt.
8.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Install the front bumper reinforcement with the 4 nuts.
9.INSTALL FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)
Attach the 2 claws to install the front bumper reinforcement extension.
10.INSTALL FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)
Use the same procedure described for the LH side.
11.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)
Install the engine side cover with the 3 bolts and 2 clips.
12.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)
Use the same procedure described for the LH side.
13.INSTALL NO. 1 ENGINE UNDER COVER (except 4WD and Pre-Runner)
Install the No. 1 engine under cover with the 5 bolts and 4 clips.
14.INSTALL FRONT BUMPER COVER
w/ Fog Light:
Connect the 2 fog light connectors.
Attach the 6 claws to install the front bumper cover.
Install the 5 clips, 2 bolts and 2 screws.
Install the 3 clips and 6 screws.
15.INSTALL RADIATOR GRILLE
16.ADJUST FOG LIGHT AIMING (w/ Fog Light)