Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2012.10
RM1840EF _59 Vehicle Exterior _009657 EXTERIOR PANELS / TRIM _0052831 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 1.INSTALL NO. 1 LOWER RADIATOR GRILLE

a.

Attach the 13 claws to install the lower radiator grille.


Hide 2.INSTALL FRONT BUMPER HOLE COVER LH

a.

Attach the 3 claws to install the front bumper hole cover.


Hide 3.INSTALL FRONT BUMPER HOLE COVER RH

HINT:

Use the same procedure described for the LH side.


Hide 4.INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)

Hide 5.INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:

Use the same procedure described for the LH side.


Hide 6.INSTALL FRONT BUMPER EXTENSION LH (w/ Outside Moulding)

a.

Install the front bumper extension with the 8 retainers.


Hide 7.INSTALL FRONT BUMPER EXTENSION RH (w/ Outside Moulding)

HINT:

Use the same procedure described for the LH side.