Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(for Flat Type)
RM1840EF _59 Vehicle Exterior _009657 EXTERIOR PANELS / TRIM _0052832 REAR BUMPER(for Flat Type) A

EXTERIOR PANELS / TRIM  REAR BUMPER(for Flat Type)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL REAR BUMPER BAR PLATE

HINT:

When installing the rear bumper bar plate, heat the rear bumper and rear bumper bar plate using a heat light.


Standard:
Item Temperature
Rear Bumper 20 to 30°C (68 to 86°F)
Rear Bumper Bar Plate 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the rear bumper or rear bumper bar plate excessively.


a.

When using a new rear bumper bar plate:

i.

Clean the rear bumper surface.


ii.

Using a heat light, heat the rear bumper surface.



b.

When reusing the rear bumper bar plate:

i.

Using a heat light, heat the rear bumper surface and rear bumper bar plate surface.


ii.

Remove the double-sided tape from the rear bumper and rear bumper bar plate.


iii.

Wipe off any tape adhesive residue with cleaner.


iv.
B279657
0.75,0.719 0.938,0.719 0.938,0.719 1.083,1.01 false 1.677,0.469 1.865,0.469 1.865,0.469 2.01,0.76 false 0.563,0.615 0.729,0.771 0.167,0.156 10 false *1 1.49,0.354 1.656,0.51 0.167,0.156 10 false *1
*1 Double-sided Tape


Install a new double-sided tape in the position shown in the illustration.



c.

Install the rear bumper bar plate.

i.

Remove the peeling paper from the face of the rear bumper bar plate.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Attach the 7 claws to install the rear bumper bar plate.



Hide 2.INSTALL REAR BUMPER PLATE LH

a.

Attach the 2 claws to install the rear bumper plate.


Hide 3.INSTALL REAR BUMPER PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 4.INSTALL REAR BUMPER PLATE

a.

Attach the 13 claws to install the rear bumper plate.


Hide 5.INSTALL REAR BUMPER ARM LH

a.

Install the rear bumper arm with the 2 bolts.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


Hide 6.INSTALL REAR BUMPER ARM RH

HINT:

Use the same procedure described for the LH side.