Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › 2012.01–2012.04
RM1840EF _59 Vehicle Exterior _009657 EXTERIOR PANELS / TRIM _0052835 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.INSTALL REAR DOOR OUTER GLASS WEATHERSTRIP LH

a.

Attach the 4 claws to install the rear door outer glass weatherstrip.


Hide 2.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 4.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

Hide 5.INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)