Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
2.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
3.REMOVE DOOR PULL HANDLE
4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
5.REMOVE REAR DOOR OUTER GLASS WEATHERSTRIP LH
| *1 | Protective Tape |
Put protective tape around the rear door outer glass weatherstrip.
Detach the 4 claws and remove the rear door outer glass weatherstrip.