Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL FRONT FENDER MUDGUARD LH
w/o Outside Moulding:
Install the front fender mudguard with the 3 screws.
w/ Outside Moulding:
Install the front fender mudguard with the 4 screws.
2.INSTALL REAR QUARTER PANEL MUDGUARD LH
Install the rear quarter panel mudguard with the 4 screws.