Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MOULDING
RM1840EF _59 Vehicle Exterior _009657 EXTERIOR PANELS / TRIM _0052839 SIDE MOULDING A

EXTERIOR PANELS / TRIM  SIDE MOULDING  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT NO. 1 WHEEL OPENING EXTENSION PAD

HINT:

When installing the front No. 1 wheel opening extension pad, heat the front wheel opening extension using a heat light.


Standard:
Item Temperature
Front Wheel Opening Extension 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the front wheel opening extension excessively.


a.

Clean the front wheel opening extension surface.

i.

Using a heat light, heat the front wheel opening extension surface.


ii.

Remove the double-sided tape from the front wheel opening extension.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B277558

Install a new front No. 1 wheel opening extension pad.

i.

Remove the peeling paper from the face of a new front No. 1 wheel opening extension pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the front No. 1 wheel opening extension pad.



Hide 2.INSTALL REAR NO. 2 WHEEL OPENING EXTENSION PAD

HINT:

When installing the rear No. 2 wheel opening extension pad, heat the rear No. 1 wheel opening extension using a heat light.


Standard:
Item Temperature
Rear No. 1 Wheel Opening Extension 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the rear No. 1 wheel opening extension excessively.


a.

Clean the rear No. 1 wheel opening extension surface.

i.

Using a heat light, heat the rear No. 1 wheel opening extension surface.


ii.

Remove the double-sided tape from the rear No. 1 wheel opening extension.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B277561

Install a new rear No. 2 wheel opening extension pad.

i.

Remove the peeling paper from the face of a new rear No. 2 wheel opening extension pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the rear No. 2 wheel opening extension pad.