Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › SFI SYSTEM › from 2012.10
RM1840EF _51 Engine / Hybrid System _009571 2TR-FBE ENGINE CONTROL _0052126 SFI SYSTEM C

2TR-FBE ENGINE CONTROL  SFI SYSTEM  P0630  VIN not Programmed or Mismatch - ECM / PCM  


DESCRIPTION

DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM, or the input VIN is incorrect. The VIN is input with the intelligent tester.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0630 VIN not Programmed or Mismatch - ECM / PCM Either condition is met (1 trip detection logic):
·

VIN is not stored in the ECM.

·

Input VIN is incorrect.


ECM Comes on DTC stored

PROCEDURE

1.READ DTC OUTPUT (CURRENT DTC)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON and turn the intelligent tester on.


c.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 234

d.

Read DTCs.

Result:
Result Proceed to
DTC P0630 is output A
DTC P0630 and other DTCs are output B


HINT:

If any DTCs other than P0630 are output, troubleshoot those DTCs first.


NOTICE:

If P0630 is stored, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the intelligent tester when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.




A

2.INSPECT VIN WITH INTELLIGENT TESTER

B

2.INSPECT VIN WITH INTELLIGENT TESTER

Result:
Proceed to
NEXT



NEXT

END